Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 266)

Xerox 4595 Copier/Printer System Administration Guide 8-108
8. Setups
Stamp Position-Left Center
This feature allows you to fine tune exactly where on the left
center of the output that your stamp is printed. The selection
made here becomes the default setting when
Left Center
is
selected for the
Stamp Position
on the
Annotation
screen
(
Output Format
tab).
Set the position in the horizontal direction within the range
0-200
and in the vertical position within the range
0-100
in1 mm
increments.
Stamp Position-Center
This feature allows you to fine tune exactly where on the center of
the output that your stamp is printed. The selection made here
becomes the default setting when
Center
is selected for the
Stamp Position
on the
Annotation
screen (
Output Format
tab).
Set the position in the horizontal direction within the range
0-200
and in the vertical position within the range
0-200
in 1 mm
increments.
Stamp Position- Right
Center
This feature allows you to fine tune exactly where on the right
center of the output that your stamp is printed. The selection
made here becomes the default setting when
Right Center
is
selected for the
Stamp Position
on the
Annotation
screen
(
Output Format
tab).
Set the position in the horizontal direction within the range
0-200
and in the vertical position within the range
0-100
in 1 mm
increments.
Stamp Position- Bottom
Left
This feature allows you to fine tune exactly where on the bottom
left of the output that your stamp is printed. The selection made
here becomes the default setting when
Bottom Left
is selected
for the
Stamp Position
on the
Annotation
screen (
Output
Format
tab).
Set the position in the horizontal direction within the range
0-100
and in the vertical position within the range
0-100
in 1 mm
increments.
Stamp Position- Bottom
Center
This feature allows you to fine tune exactly where on the bottom
center of the output that your stamp is printed. The selection
made here becomes the default setting when
Bottom Center
is
selected for the
Stamp Position
on the
Annotation
screen
(
Output Format
tab).
Set the position in the horizontal direction within the range
0-100
and in the vertical position within the range
0-200
in 1 mm
increments.