Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 284)

Xerox 4595 Copier/Printer System Administration Guide 8-126
8. Setups
screen.
NOTE 1: When a port is set to Disabled, the corresponding
items that are associated with that port do not appear.
NOTE 2: Depending on the amount of data sent from the
client, increasing the memory capacity may not change the
amount of time that it takes to release the client.
PostScript Memory
Specify the memory capacity used for PostScript. Set a value
from 8.00-96.00 MB, in 0.25 MB increments.
HP-GL/2 Auto Layout
Memory
Specify the memory capacity used for HP-GL/2. Set a value from
64-5120 KB, in 32 KB increments.
NOTE: The maximum value that can be set for both the PostScript
Memory and HP-GL/2 Auto Layout Memory options vary
according to the available memory capacity.
Receiving Buffer - LPD
Spool
•
Off:
When Off is selected, the machine will not use spooling.
During the LPD print process for one client, data cannot be
received over that same interface from a different client. Set a
value for the dedicated LPD receiving buffer memory capacity
from 1024-2048 KB, in 32 KB increments.
•
Memory Spool:
When selected, the machine will use
spooling. The receiving buffer for spooling uses memory.
When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling, from 0.50 MB to
32.00 MB, in 0.25 MB increments.
NOTE: Notice that print data exceeding the set memory
capacity is not accepted. In such cases, select Hard Disk or
Off.
•
Hard Disk Spool:
When selected, the machine will use
spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - NetWare
Set the NetWare receiving buffer. Set a value from 64 to 1024 KB,
in 32 KB increments.
Receiving Buffer - SMB
Spool
•
Off:
When Off is selected, the machine will not use spooling.
While SMB print processing is being carried out for one client,
data cannot be received over the same interface from another
client.
Set a value for the dedicated SMB receiving buffer memory
capacity from 64 to 1024 KB, in 32 KB increments.
•
Memory Spool:
When selected, the machine will use
spooling. The receiving buffer for spooling uses memory.
When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling from 0.50 MB to
32.00 MB, in 0.25 MB increments.