Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 372)

Xerox 4595 Copier/Printer System Administration Guide 9-12
9. Troubleshooting
When the print output is not as you expected
Notes and Restrictions
The following are the notes and restrictions for using TCP/IP
(LPD).
Configuration on the Machine
• Take maximum care with the IP address settings. IP
addresses are managed throughout the system as a whole.
The configuration should be performed only after consulting
with your network administrator.
• Subnet Mask and Gateway addresses may be necessary
depending on the network environment. Confirm with the
network administrator and set up the necessary items.
• When the port status is set to Enable, it sometimes
automatically switches to Disable if the machine has
insufficient memory. If this happens, either set an unused port
to Disable, or adjust the assigned memory size.
• Adjust the receiving buffer
lpd (Spool)
size according to
usage. When the receiving buffer
lpd (Spool)
size is smaller
than the transmitted data, the machine may not be able to
receive the data.
Configuration on the Computer
• Take maximum care with the IP address settings. IP
addresses are managed throughout the system as a whole.
The configuration should be performed only after consulting
with your network administrator.
• When performing network settings (IP address, and so forth)
on a host under the NIS (Network Information Service)
management, consult with the NIS administrator.
Cause Check point Remedy
Selected print language on the
machine does not match the print
language of the print data.
Confirm the selected print
language on the machine and the
print language of the print data.
Select the print language on the
machine to match the print data.
The computer is not using the print
driver supplied with the machine
(using a print driver from another
company).
Confirm if the print driver on the
computer is the one supplied with
the machine.
Select the print driver supplied
with the machine on the computer.
If it does not appear on the
selection list, install the print driver
supplied with the machine and
select it. The operation is not
guaranteed if another print driver
is used.