Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 113)

Xerox 4595 Copier/Printer System Administration Guide 5-23
5. Using the Scan Service
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter “0.0.0.0.”
5. Select
Close
repeatedly until the
System Settings
screen is
displayed.
6. Select
Exit
.
7. After the machine is restarted, print out the Printer Settings
List to confirm that either the SMB port or FTP client port is
enabled and the IP addresses are configured.
Configuration on the computer
This section describes the configuration procedure for the
computer.
Using with FTP
Create a destination directory/folder for your files. this directory/
folder should be created on the FPT server where you logged in.
Using with SMB
Create a folder on the computer and configure it as a shared
folder.