Xerox 4595 con Xerox FreeFlow DocuSP Print Controller-15553 - Manual (Page 373)

Xerox 4595 Copier/Printer System Administration Guide 9-13
9. Troubleshooting
Switching Off the Power
Check the following points when switching off the machine:
•
When the
lpd (Spool)
is set to
Memory
.
All print data spooled within the machine memory, including
the data which is being printed is erased. The print data will
not be found when the machine is powered on again.
However, if the power was switched off immediately after a
computer instructed a print job, the job may remain on the
computer. In this case, the stored data on the computer will be
printed out in order before any later instructions when the
machine is powered back on.
• When the
lpd (Spool)
is set to
Hard Disk
.
All print data spooled in the machine hard disk, including the
data which is being printed is preserved. In this case, the
stored data on the machine hard disk will be printed out in
order before any later instructions when the machine is
powered back on.
• When the
lpd (Spool)
is set to
Off
.
All print data spooled in the machine receiving buffer, including
the data which is being printed is erased. The print data will
not be found when the machine is powered on again.
However, if the power was switched off immediately after a
computer instructed a print job, the job may remain on the
computer. In this case, the stored data on the computer will be
printed out in order before any later instructions when the
machine is powered back on.
While Printing
• When the
lpt (Spool)
is set to either
Hard Disk
or
Memory
.
If the transmitted print data size exceeded the available
amount of either hard disk or memory, the print data will not be
received.
NOTE: When the print data has exceeded the receivable size,
some computers may immediately re-transmit the print data.
When this occurs, the computer appears to be halted. Deal with
this problem by canceling the print data transmission from the
computer.
• When the
lpd (Spool)
is set to
Off
.
While the machine is receiving a print request from a
computer, the machine cannot accept any print requests from
other computers.
• When the IP address of a computer or a computer name is
changed.