Konica Minolta eCopy - Manual (Page 67)

eCopy ShareScan OP Installation and Setup Guide | 59
Configuring connectors
An eCopy ShareScan OP system can use any of the base connectors provided by eCopy, Inc. as well
as add-on connectors or services that you have purchased.
You configure connectors by creating connector profiles that specify various settings, such as the
appearance of the connector’s button and the image format you want to use. You can create
multiple profiles for each connector and each connector profile can be activated on multiple
devices. You can also publish groups of connector profiles to all eCopy-enabled devices on the
network.
Overview
Managing connectors and services involves the following tasks:
■ Installing connectors and services (see “Installing connectors and services” on page 60).
■ Removing add-on connectors (see “Removing add-on connectors” on page 60).
■ Creating and saving connector profiles (see “Creating and saving connector profiles” on
page 61).
■ Activating connector profiles (see “Activating connector profiles” on page 62).
This chapter also provides information about the following tasks:
■ Configuring properties that are common to many connectors (see “About configuring general
Properties settings” on page 63). For example, you configure the Display settings for all the
connectors and you configure the fax address format for all the fax connectors.
■ Configuring connector services (see “About configuring connector Services” on page 75). For
example, you configure document settings, such as encryption, for most of the connectors.
■ Configuring individual connectors (see “Connector-specific configuration information” on
page 80).