Konica Minolta eCopy - Manual (Page 22)

14 | Quick Start: Installing and setting up eCopy ShareScan OP
Installing the UPDD driver
The Universal Pointing Device Driver (UPDD) is used to configure the touch screen. If you are
using a new ScanStation, you must calibrate the touch screen. If you are using an existing
ScanStation, you probably do not need to calibrate the touch screen.
To install the driver:
1 Insert the eCopy ShareScan OP CD (Disk 1) in the drive.
2 When the Launch window opens, click Drivers .
3 Click Explore Touchscreen Drivers .
4 Run Setup.exe .
5 When the Welcome window opens, click Next .
6 When the License Agreement window opens, read the agreement, then click Accept . The
Select folder window opens.
7 Follow the prompts on subsequent screens, using the following information to specify the
driver settings:
8 When the Ready to install window opens, click Next to finish the installation.
9 When the installation is complete, click Finish .
Window name Field Value
Number of devices Number of devices 1
Desktop segment Logical desktop segment Whole Desktop
Select controller Controller type
DynaPro, SC3, Serial
1
1
Do not select any controller type other than “DynaPro, SC3, Serial”
Port Port COM1