Konica Minolta eCopy - Manual (Page 181)

eCopy ShareScan OP Installation and Setup Guide | 173
10 When you are ready to send the document, press the delivery button for the connector, which
is typically the
Send button. After the connector sends the document, a screen similar to the
following appears. This screen appears if Session Logon is enabled for the connector.
Select one of the post-scanning options:
Option Description
Log Out Displays the Logon screen. This option is displayed only if Session Logon is
enabled.
New Job Displays the main ShareScan OP screen. This option is displayed only if
Session Logon is enabled.
Done Displays the main ShareScan OP screen. This option is displayed only if
Session Logon is not enabled.
New Document Displays the scan preview screen so that you can scan a new document
using the current settings. Place the new document in the feeder or on the
glass, then press Scan More. (If you are using a device with an embedded
client, you can press the device’s Start button to scan the new document.
New Destination Allows you to send the scanned document to another connector. Select the
target connector in the list, then press New Destination. The client opens
the target connector.