Allied Telesis AT-S63 - Manual (Page 85)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 85
Creating an SNMP Community String
To create a new SNMP community string, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 17 on page 83.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 & SNMPv2c Community.
The Configure SNMPv1 & SNMPv2c Community menu is shown in
Figure 18.
Figure 18. SNMPv1 & SNMPv2c Community Menu
This menu lists the current community strings on the switch and
their attributes. For attribute definitions, refer to ”SNMPv1 and
SNMPv2c Overview” on page 80.
4. Type 1 to select Create SNMP Community.
The following prompt is displayed:
Enter SNMP Community Name:
5. Enter the new SNMP community string. The name can be from one to
fifteen alphanumeric characters. Spaces are allowed.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Configure SNMPv1 & SNMPv2c Community
Community Name AccessMode Status OpenAcc Manager IP Addr Trap Rec IP
-------------------------------------------------------------------------
Private
Read|Write Enabled Yes
Public Read Enabled Yes
1 - Create SNMP Community
2 - Delete SNMP Community
3 - Modify SNMP Community
U - Update Display
R - Return to Previous Menu
Enter your selection?