Allied Telesis AT-S63 - Manual (Page 293)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 293
Selecting MSTP as the Spanning Tree Protocol
To select and activate MSTP as the spanning tree protocol, or to disable
spanning tree, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. To change the active version of spanning tree on the switch, type 2 to
select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP, M-MSTP):
3. Type M to select MSTP.
Note
A change to the active spanning tree is automatically saved on the
switch.
4. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
5. Type E to enable spanning tree or D to disable it. The default is
disabled.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.