Allied Telesis AT-S63 - Manual (Page 591)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 591
Modifying a Certificate
The procedure in this section modifies a certificate. (The certificate to be
modified must be in the certificate database.) Here are the certificate
items you can modify:
❑ State - trusted or untrusted
❑ Type - EE, CA, or Self
Note
These parameters have no affect on the operation of a certificate.
They are included only for informational purposes when the
certificate is displayed in the certificate database.
This procedure starts from the X509 Certificate Management menu. If
you are unsure how to access the menu, perform steps 1 to 4 in the
procedure ”Adding a Certificate to the Database” on page 588.
To modify a certificate, perform the following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 3 to select
Keys/Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 176
on page 560.
3. From the Keys/Certificate menu, type 3 to select Public Key
Infrastructure (PKI) Configuration.
The Public Key Infrastructure (PKI) Configuration menu is shown
in Figure 182 on page 585.
4. From the Public Key Infrastructure (PKI) Configuration menu, type 2
to select X509 Certificate Management.
The X509 Certificate Management menu is shown in Figure 183
on page 585.
5. From the X509 Certificate Management menu, type 4 to select Modify
Certificate.
The following prompt is displayed:
Enter a certificate name ->