Deleting an snmpv3 view table entry – Allied Telesis AT-S63 User Manual

Page 341

AT-S63 Management Software Menus Interface User’s Guide

Section II: Advanced Features

341

making changes to an SNMPv3 View Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.

N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 View Table to the configuration file. After making
changes to an SNMPv3 View Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes. Allied
Telesyn recommends this storage type.

Note

The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 View Table entry takes effect immediately.

9. After making changes, type R until you return to the Main Menu. Then

type S to select Save Configuration Changes.

Deleting an

SNMPv3 View

Table Entry

You may want to delete an entry from the SNMPv3 View Table. After you
delete an SNMPv3 View Table entry, there is no way to undelete, or
recover the entry.

To delete an entry in the SNMPv3 View Table, perform the following
procedure:

1. Follow steps 1 through 5 in the procedure described in ”Creating an

SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.

The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.

2. From the Configure SNMPv3 Table menu, type 3 to select Configure

SNMPv3 View Table.

The SNMPv3 View Table is shown in Figure 109 on page 339.

3. From the SNMPv3 View Table, type 2 to select Delete SNMPv3 Table

Entry.

The following prompt is displayed:

Enter View Name:

4. Enter the View Name of the View Table entry you want to delete.