Allied Telesis AT-S63 - Manual (Page 135)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 135
3 - Display Dynamic
This selection displays only the dynamic addresses learned on the
ports on the switch.
4 - Display by Port
This selection displays the dynamic and static MAC addresses of a
particular port. When you select this option, you are prompted for
a port number. You can specify more than one port at a time.
5 - Display Specified MAC
This selection displays the port number on which a MAC address
was assigned or learned.
If you want to know on which port a particular MAC address was
learned, you can display the MAC address table and scroll through
the list looking for the MAC address. But if the switch is part of a
large network, finding the address could prove difficult.
When you use the Display Specified MAC selection, you specify
the MAC address and the AT-S63 management software
automatically locates the port on the switch where the device is
connected.
6 - Display by VLAN ID
Displays all the static and dynamic addresses learned on the
tagged and untagged ports of a specific VLAN. When you select
this option, you are prompted for the VLAN ID number of the
VLAN. You can specify only one VLAN at a time
7 - Display on Base Ports
This selection displays the static and dynamic MAC addresses
learned on the base ports on the AT-9400 Series switch. It does
not display any addresses assigned or learned on any uplink ports.