Allied Telesis AT-S63 - Manual (Page 58)

Chapter 3: Basic Switch Parameters
58 Section I: Basic Features
Rebooting a Switch
This procedure reboots the switch.
Note
Any configuration changes not saved are lost after the switch
reboots. To save your configuration changes, return to the Main
Menu and type S to select Save Configuration Changes.
To reboot the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7.
Figure 7. System Utilities Menu
3. From the System Utilities menu, type 5 to select Reboot the switch.
The following prompt is displayed:
The switch is about to reboot. Do you want to proceed?
[Yes/No] ->
4. Type Y to reboot the switch or N to cancel the procedure.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
System Utilities
1 - File Operations
2 - Downloads and Uploads
3 - Ping a Remote System
4 - Reset to Factory Defaults
5 - Reboot the Switch
R - Return to Previous Menu
Enter your selection?