Allied Telesis AT-S63 - Manual (Page 654)

Chapter 30: TACACS+ and RADIUS Protocols
Section IV: Security 654
Configuring RADIUS
To configure the RADIUS protocol, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
The Authentication Configuration menu is shown in Figure 205 on
page 648.
3. Type 4 to select RADIUS Configuration.
The RADIUS Client Configuration menu is shown in Figure 208.
Figure 208. RADIUS Client Configuration
4. Adjust the following parameters as necessary.
Global Encryption Key
This parameter specifies the encryption key for the RADIUS
servers. This option is useful if you will be entering more than one
RADIUS server and all the servers share the same encryption key.
The default is ATI.
Global Server Timeout period
This parameter specifies the maximum amount of time the switch
waits for a response from a RADIUS server before assuming that
the server does not respond. If the timeout expires and the server
has not responded, the switch queries the next RADIUS server in
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 10 second(s)
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?