Allied Telesis AT-S63 - Manual (Page 304)

Chapter 17: MSTP
304 Section II: Advanced Features
Adding, Removing, or Modifying VLAN Associations to MSTI
IDs
When you create a new MSTI ID, you are given the opportunity of
associating VLANs to it. But after an MSTI ID is created, you may want to
add more VLANs to it, or perhaps remove VLANs. This procedure
explains how to associate VLANs on the switch to an existing MSTI ID
and also how to remove VLANs. Before performing this procedure, note
the following:
❑ You must create a MSTI ID before you can assign VLANs to it. To
create a MSTI ID, refer to ”Creating, Deleting, and Modifying MSTI
IDs” on page 301.
❑ You can assign a VLAN to only one MSTI. By default, a VLAN, when
created, is associated with the CIST instance, which has a MSTI ID
of 0.
❑ An MSTI can contain any number of VLANs.
This section contains the following procedures:
❑ ”Adding or Removing a VLAN from an MSTI ID” next
❑ ”Associating a VLAN to an MSTI ID” on page 305
❑ ”Removing a VLAN from an MSTI ID” on page 306
❑ ”Associating VLANs to an MSTI ID and Deleting All Associated
VLANs” on page 307
❑ ”Clearing VLAN to MSTI Associations” on page 308
Adding or
Removing a
VLAN from an
MSTI ID
To add or remove a VLAN from an MSTI ID, perform the following
procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 95 on page 294.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 97 on page 299.
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.