Allied Telesis AT-S63 - Manual (Page 333)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 333
Modifying an
SNMPv3 User
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
❑ ”Modifying the Authentication Protocol and Password” on page
333
❑ ”Modifying the Privacy Protocol and Password” on page 335
❑ ”Modifying the Storage Type” on page 336
Modifying the Authentication Protocol and Password
To modify the Authentication Protocol and Password in an SNMPv3 User
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in ”Configuring
the SNMPv3 User Table” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 User Table menu is shown in Figure 106
on page 329.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 107 on page 329.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.
The Modify SNMPv3 User Table is shown in Figure 108.
Figure 108. Modify SNMPv3 User Table Menu
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Modify SNMPv3 User Table
Engine ID ................. 80:00:00:CF:03:00:30:84:FD:57:DA
User Name ................. wilson
Authentication Protocol ... SHA
Privacy Protocol .......... DES
Storage Type .............. NonVolatile
Row Status ................ Active
1 - Set Authentication Protocol & Password
2 - Set Privacy Protocol & Password
3 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?