Allied Telesis AT-S63 - Manual (Page 60)

Chapter 3: Basic Switch Parameters
60 Section I: Basic Features
Configuring the Manager and Operator Passwords
There are two levels of management access on an AT-9400 Series switch:
manager and operator. When you log in as manager, you can view and
configure all of a switch’s operating parameters. When you log in as an
operator, you can only view the operating parameters; you cannot
change any values.
You log in as a manager or an operator when you enter the appropriate
username and password when you start an AT-S63 management
session. The default password for manager access is “friend.” The default
password for operator access is “operator.” Passwords are case sensitive.
To change the manager or operator password, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
The Authentication Configuration menu is shown in Figure 8.
Figure 8. Authentication Configuration Menu
3. From the Authentication Configuration menu, type 5 to select
Passwords Configuration.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Authentication Configuration
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?