Allied Telesis AT-S63 - Manual (Page 396)

Chapter 18: SNMPv3
396 Section II: Advanced Features
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Target Parameters Table to the configuration file.
After making changes to an SNMPv3 Target Parameters Table
entry with a NonVolatile storage type, the S - Save Configuration
Changes option appears on the Main Menu, allowing you to save
your changes. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Target Parameters Table entry will take effect
immediately.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Target
Parameters
Table Entry
You may want to delete an entry from the SNMPv3 Target Parameters
Table. When you delete an SNMPv3 Target Parameters Table entry, there
is no way to undelete, or recover, the entry.
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Parameters Table.
The Configure SNMPv3 Parameters Table menu is shown in Figure
119 on page 393.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Parameters Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
4. Enter a Target Parameters Name.