Allied Telesis AT-S63 - Manual (Page 445)

AT-S63 Management Software Menus Interface User’s Guide
Section III: VLANs 445
Example of Creating a Port-based VLAN
The following procedure creates the Sales VLAN illustrated in ”Port-
based Example 1” on page 433. This VLAN will be assigned a VID of 2 and
will consist of four untagged ports, ports 1, 2, 4, and 6. The VLAN will not
contain any tagged ports.
To create the Sales VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 135 on page
441.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 136 on page 442.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 137 on page 442.
4. Type 1 to select VLAN Name and enter “Sales”.
5. Type 2 to select VLAN ID (VID) and enter “2”. This is the VID value for
the new VLAN.
6. Type 4 to select Untagged Ports and enter “1-2,4,6”. These are the
untagged ports of the VLAN. Press Return.
7. Type C to select Create VLAN.
8. After the switch displays the prompt notifying you that it created the
VLAN, press any key.
The new Sales VLAN has now been created.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.