Allied Telesis AT-S63 - Manual (Page 332)

Chapter 18: SNMPv3
332 Section II: Advanced Features
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 User Table to nonvolatile memory. After making
changes to an SNMPv3 User Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes. Allied
Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 User Table entry takes effect immediately.
12. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 User
Table Entry
You may want to delete an entry from the SNMPv3 User Table. When you
delete an entry in the SNMPv3 User Table, there is no way to undelete, or
recover the entry.
To delete an entry in the SNMPv3 User Table, perform the following
procedure.
1. Follow steps 1 through 5 in the procedure described in ”Configuring
the SNMPv3 User Table” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 107 on page 329.
3. From the SNMPv3 User Table, type 2 to select Delete SNMPv3 Table
Entry.
The following prompt is displayed:
Enter User (Security) Name:
4. Enter the User Name of the User Table entry you want to delete.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Enter Y to delete the user or N to save the user.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.