Allied Telesis AT-S63 - Manual (Page 51)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 51
Configuring the IP Address, Switch Name, and Other Basic
Parameters
The procedure in this section explains how to manually assign an IP
address, subnet mask, and gateway address to the switch from a local or
Telnet management session. (If you want the switch to obtain its IP
configuration from a DHCP or BOOTP server on your network, go to the
procedure ”Activating the BOOTP and DHCP Client Software” on page
54.)
This procedure also explains how to assign a name to the switch, along
with the name of the administrator responsible for maintaining the unit
and the location of the switch.
To manually set a switch’s IP address, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4.
Figure 4. System Administration Menu
2. From the System Administration menu, type 2 to select System
Configuration.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
System Administration
1 - System Information
2 - System Configuration
3 - Console (Serial/Telnet) Configuration
4 - Web Server Configuration
5 - SNMP Configuration
6 - Authentication Configuration
7 - Management ACL
8 - Event Log
9 - System Utilities
R - Return to Previous Menu
Enter your selection?