Allied Telesis AT-S63 - Manual (Page 376)

Chapter 18: SNMPv3
376 Section II: Advanced Features
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a Notify Type
To modify the Notify Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 6 to select Configure
SNMPv3 Notify Table.
The Configure SNMPv3 Notify Table menu is shown in Figure 115
on page 372.
3. From the Configure SNMPv3 Notify Table menu, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table is shown in Figure 116 on page
375.
4. To modify the Notify Type, type 2 to select Set Notify Type.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Enter Notify Type [T-Trap, I-Inform]:
6. Enter one of the following message types:
T-Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expect a response from the host.
I-Inform
Indicates this notify table is used to send inform messages. With
this message type, the switch expects a response from the host.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.