Allied Telesis AT-S63 - Manual (Page 416)

Chapter 18: SNMPv3
416 Section II: Advanced Features
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
❑ ”Displaying the Display SNMPv3 User Table Menu” on page 416
❑ ”Displaying the Display SNMPv3 View Table Menu” on page 417
❑ ”Displaying the Display SNMPv3 Access Table Menu” on page 418
❑ ”Displaying the Display SNMPv3 SecurityToGroup Table Menu” on
page 419
❑ ”Displaying the Display SNMPv3 Notify Table Menu” on page 420
❑ ”Displaying the Display SNMPv3 Target Address Table Menu” on
page 421
❑ ”Displaying the Display SNMPv3 Target Parameters Table Menu”
on page 421
❑ ”Displaying the Display SNMPv3 Community Table Menu” on
page 422
Displaying the
Display SNMPv3
User Table
Menu
This section describes how to display the Display SNMPv3 User Table
menu. For information about the SNMPv3 User Table, see ”Creating an
SNMPv3 User Table Entry” on page 328.
To display the Display SNMPv3 User Table menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 17 on page 83.
3. From the SNMP Configuration menu, type 6 to select Display SNMPv3
Table.