Allied Telesis AT-S63 - Manual (Page 604)

Chapter 27: PKI Certificates and SSL
604 Section IV: Security
Configuring SSL
To configure the SSL protocol, perform the following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 5 to select Secure Socket
Layer (SSL).
The Secure Socket Layer (SSL) menu is shown in Figure 190.
Figure 190. Secure Socket Layer (SSL) Menu
3. Type 1 to select Maximum Number of Sessions to increase the
number of sessions.
The following prompt is displayed:
Enter maximum SSL sessions value -> [1 to 100] 50
Enter a value from 1 to 100. The maximum number of sessions is
used to speed up a connection. By increasing the number of
sessions, you increase HTTPS performance. However, increasing
the number of sessions also increases the memory requirements.
The default is 50.
4. Type 2 to select Session Cache Timeout to increase or decrease the
timer that determines when the session cache times out.
The following prompt is displayed:
Enter Cache timeout value -> [1 to 600] 300
Enter a value, in seconds, from 1 to 600. The default is 300
seconds.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Secure Socket Layer (SSL)
1 - Maximum Number of Sessions......... 50
2 - Session Cache Timeout.............. 300 seconds
R - Return to Previous Menu
Enter your selection?