Removing a vlan from an msti id – Allied Telesis AT-S63 User Manual
Page 306
Chapter 17: MSTP
306
Section II: Advanced Features
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 98 on page
305.
5. From the VLAN-MSTI Association menu, type 1 to select Add VLANs to
MSTI.
The following prompt is displayed:
Enter the MSTI ID
6. Enter the MSTI ID to which you want to associate a VLAN.
A prompt similar to the following is displayed:
Enter the list of VLANs:
7. Enter the VLAN ID of the virtual LAN you want to associate with the
MSTI ID. You can enter more than one VLAN at a time (for example,
2,4,7). To view VIDs, refer to ”Displaying VLANs” on page 451.
The MSTI ID retains any VLANs already associated with it when
new VLANs are added.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Removing a
VLAN from an
MSTI ID
To remove a VLAN from an MSTP ID, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 95 on page 294.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 97 on page 299
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 98 on page
305.
5. From the VLAN-MSTI Association menu, type 2 to select Delete VLANs
from MSTI.
The following prompt is displayed:
Enter the MSTI ID