Allied Telesis AT-S63 - Manual (Page 294)

Chapter 17: MSTP
294 Section II: Advanced Features
Configuring MSTP Bridge Settings
To configure a bridge’s MSTP settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. From the Spanning Tree menu, type 3 to select Configure Active
Protocol.
The MSTP menu is shown in Figure 95.
Figure 95. MSTP Menu
3. Adjust the following parameters as necessary.
1 - Force Version
This selection determines whether the bridge operates with MSTP
or in an STP-compatible mode. If you select MSTP, the bridge
operates all ports in MSTP, except for those ports that receive STP
or RSTP BPDU packets. If you select Force STP Compatible, the
bridge uses its MSTP parameter settings, but sends only STP BPDU
packets from the ports.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
MSTP Menu
1 - Force Version .......... MSTP
2 - Hello Time ............. 2
3 - Forwarding Delay ....... 15
4 - Max Age ................ 20
5 - Max Hops ............... 20
6 - Configuration Name .....
7 - Revision Level ......... 0
8 - Bridge Identifier ...... 00:30:24:1E:EE:11
9 - Root Identifier ........ 00:30:84:EF:CC:DD
C - CIST Menu
M - MSTI Menu
V - VLAN-MSTI Association Menu
P - MSTP Port Parameters
D - Reset MSTP to Defaults
R - Return to Previous Menu
Enter your selection?