Allied Telesis AT-S63 - Manual (Page 338)

Chapter 18: SNMPv3
338 Section II: Advanced Features
Configuring the SNMPv3 View Table
This section contains a description of the SNMPv3 View Table and how
to create, delete, and modify table entries. Creating this table, allows you
to specify a view using the following parameters:
❑ Subtree OID
❑ Subtree Mask
❑ MIB OID Table View
To configure the SNMPv3 View Table, you need to be very familiar with
the OID table. You can be very specific about the view a user can or
cannot access—down to a column or row of the table. AT-S63 supports
the Internet subtree of the OID table.
There are three functions you can perform with the SNMPv3 User Table:
❑ ”Creating an SNMPv3 View Table Entry” on page 338
❑ ”Deleting an SNMPv3 View Table Entry” on page 341
❑ ”Modifying an SNMPv3 View Table Entry” on page 342
Creating an
SNMPv3 View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure.
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.