Allied Telesis AT-S63 - Manual (Page 389)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 389
Enter a Tag List of up to 256 alphanumeric characters. Use a space
to separate entries. This list consists of a tag or list of tags you
configured in a Configure SNMPv3 Notify Table entry with the
Notify Tag parameter. See ”Creating an SNMPv3 Notify Table
Entry” on page 371.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Parameters Field
To modify the Target Parameters field in an SNMPv3 Target Address
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is shown in
Figure 117 on page 380.
3. From the Configure SNMPv3 Target Address Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is shown in
Figure 118 on page 384.
4. To modify the Target Parameters field, type 6 to select Set Target
Parameters.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Target Parameters:
6. Enter a Target Parameters Name.