Allied Telesis AT-S63 - Manual (Page 648)

Chapter 30: TACACS+ and RADIUS Protocols
Section IV: Security 648
Enabling or Disabling TACACS+ or RADIUS
To enable or disable the server-based authentication feature on the
switch and to configure the RADIUS or TACACS+ settings, perform one
of the following procedures.
Enabling
TACACS+ or
RADIUS
To enable TACACS+ or RADIUS, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
The Authentication Configuration menu is shown in Figure 205.
Figure 205. Authentication Configuration Menu
Note
Selection 5, Passwords Configuration, is described in ”Configuring
the Manager and Operator Passwords” on page 60.
3. To select the active authentication protocol, type 2 to select
Authentication Method.
The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active on the switch at a time.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Authentication Configuration
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?