Allied Telesis AT-S63 - Manual (Page 209)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 209
Enabling or Disabling the Event Logs
To enable or disable the event logs, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 61.
Figure 61. Event Log Menu
3. To enable or disable event logging, type 1 to toggle Event Logging
between the two options:
Enabled
The switch immediately begins to add events to the logs. This is
the default.
Disabled
Event logging is halted if this option was previously set to
Enabled, or no event log is created.
Note
When the event log feature is disabled and the switch is rebooted,
initialization events are still logged even though the Event Log
feature is disabled. The Event Logging option determines whether
further events are logged.
Allied Telesyn AT-9400 Series - ATS63 V1.0.0
Production Switch
User: Manager 00:14:33 15-Mar-2004
Event Log
1 - Event Logging .......... Enabled
2 - Log Full Action ........ Wrap
3 - Event Output ........... Temporary (Memory)
4 - Event Order ............ Chronological
5 - Event Mode ............. Normal
6 - Event Severity ......... E, W, I
7 - Event Module ........... All
C - Clear Log
S - Save Log to File
V - View Log
R - Return to Previous Menu
Enter your selection?