Allied Telesis AT-S63 - Manual (Page 353)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 353
protocol and authenticate SNMP entities. This level provides the
greatest level of security. You can select this value if you
configured the Security Model parameter with the SNMPv3
protocol.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
7. Enter Y to delete the view or N to save the view.
The following prompt is displayed:
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Access
Table Entry
This section describes how to modify parameters in an SNMPv3 Access
Table entry. For each entry in the SNMPv3 Access Table, you can modify
the following parameters:
❑ Read View Name
❑ Write View Name
❑ Notify View Name
❑ Storage Type
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with
the View Name parameter in the SNMPv3 View Table. This is the only
way to associate a Group Name with these Views. See ”Creating an
SNMPv3 View Table Entry” on page 338.
See the following procedures:
❑ ”Modifying the Read View Name” on page 353
❑ ”Modifying the Write View Name” on page 356
❑ ”Modifying the Notify View Name” on page 358
❑ ”Modifying the Storage Type” on page 360
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.