Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 68)

56 Brocade Virtual ADX Graphical User Interface Guide
53-1003242-01
Configuring network interfaces and IP addresses
6
Enabling or disabling an interface
You can enable or disable an interface from the Summary page.
To enable or disable an interface, perform the following steps within the Configure tab.
1. Click Network on the menu bar.
2. From the sidebar, select Interfaces.
The list of all the configured interfaces is displayed in the main page as shown in Figure 43 .
FIGURE 43 Enabling or disabling an interface
3. Select an interface from the table and perform one of the following actions:
• Click Enable at the bottom of the Summary page to enable the interface.
• Click Disable to disable the interface.
For more information on enabling or disabling an interface, refer to the Brocade Virtual ADX Switch
and Router Guide.
Editing an IP interface
To edit an IP interface on the Brocade Virtual ADX, perform the following steps within the Configure
tab.
1. Click Network on the menu bar.
2. From the sidebar, select Interface.
The Summary tab is displayed. See Figure 42 .