Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 166)

154 Brocade Virtual ADX Graphical User Interface Guide
53-1003242-01
Access Control Lists
9
5. Under Source, provide the following information:
• Any: Select the check box for ACL to use any source IP or host.
• Click Source IP or Source Host.
• Source IP: Enter the source IP address based on which a standard ACL permits or denies
the packets.
NOTE
The Source IP field is enabled if you select the Source IP option.
• Source Host: Enter the name of the source host.
NOTE
The Source Host field is enabled if you select the Source Host option.
• Source Mask: Enter the subnet mask of the source IP address.
• Port Operator: Select one of the following options to specify a comparison operator for the
TCP or UDP port number. This option is enabled only when you specify TCP or UDP as the IP
protocol in Protocol Match:
• None: The policy does not apply any comparison operator for the TCP or UDP port
number.
• Greater than: The policy applies to TCP or UDP port numbers greater than the port
number or name you enter.
• Less than: The policy applies to TCP or UDP port numbers that are less than the port
number or name you enter.
• Equal: The policy applies to TCP or UDP port name or number you enter.
• Not equal: The policy applies to all TCP or UDP port numbers except the port number
or name you enter.
• Range: The policy applies to all TCP or UDP port numbers that are between the first
and second port number or name you enter. Enter the range in the Port Match field.
The range is from 0 through 65,535.