Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 67)

Brocade Virtual ADX Graphical User Interface Guide 55
53-1003242-01
Chapter
6
Network Settings
In this chapter
• Configuring network interfaces and IP addresses . . . . . . . . . . . . . . . . . . . . 55
• Configuring static routes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
• Configuring VLANs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62
Configuring network interfaces and IP addresses
The Brocade Virtual ADX allows you to edit the interface configurations and add loopback
interfaces.
To display the interfaces on the Brocade Virtual ADX, perform the following steps within the
Configure tab.
1. Click Network on the menu bar.
2. From the sidebar, select Interface.
The Summary tab is displayed. See Figure 42 .
FIGURE 42 Interface summary tab
The Summary tab displays a list of configured IP interfaces. Each entry in the list includes the
interface ID, interface name, type, Admin and runtime status, primary ID and MAC address.