Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 267)

Brocade Virtual ADX Graphical User Interface Guide 255
53-1003242-01
Appendix
A
Troubleshooting
In this appendix
• Unable to open web interface. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 255
• Web interface does not reflect changes based on the latest image . . . . . 256
• RSL error (#2032 Stream Error) when launching the web interface . . . . . 256
Unable to open web interface
Problem
The Brocade Virtual ADX web interface does not open.
Solution
Verify the following items to resolve this problem:
• Make sure that the following services are enabled on the device:
- Hypertext Transfer Protocol (HTTP)
- Simple Object Access Protocol (SOAP)
- Secure HTTP (HTTPS)
The HTTP and SOAP services are enabled by default. However, to enable HTTPS, ensure that
the device supports SSL and then generate a SSL certificate. The SSL protocol uses digital
certificate and a private-public key pair to establish a secure connection. To enable SOAP
service, run the following command in the CLI.
VirtualADX# web-management soap-service
• Make sure that the web-management services are enabled in the Brocade Virtual ADX. If not,
after entering the privilege mode, run the following command in the CLI to enable the
web-management services.
VirtualADX# web-management enable
VirtualADX# web-management http
VirtualADX# web-management https
VirtualADX# crypto-ssl certificate generate default_cert