Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 65)

Brocade Virtual ADX Graphical User Interface Guide 53
53-1003242-01
Device management
5
4. Click the Telnet Allowed Clients button.
The Telnet Allowed Clients tab is displayed. See Figure 40 .
FIGURE 40 Telnet Allowed Clients tab
The Telnet Allowed Clients tab has the following controls. See Figure 19 .
In addition to the information in the table, this tab lets you set the following value:
• Client IP
• MAC (V6 only)
Use the Telnet Allowed Clients page to perform the following functions:
• Populate the required fields (IP) and click Add to add the Telnet Allowed Client.
• Click Apply at the bottom right corner to apply any changes you have made.
• Click Reset to discard all changes.
• Select a listed entry and click the Delete button to delete that specific Telnet Allowed Client.
TFTP on VLAN controls
To display the TFTP on VLAN controls, perform the following actions in the Configure tab:
1. Click System on the menu bar.
2. From the sidebar, select Device Management.
TABLE 19 Telnet Allowed Clients tab controls
Column Content
Client IP IP address for authorized client. Once listed, it cannot be altered; it can only be deleted.
MAC (V6 only) MAC mask used by IPv6 addresses