Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 169)

Brocade Virtual ADX Graphical User Interface Guide 157
53-1003242-01
Access Control Lists
9
5. Under Source, provide the following information:
• Source IP: Enter the source IP address based on which the ACL permits or denies the
packets.
• Source Mask: Enter the subnet mask of the source IP address.
• Any: Select the check box to enable the ACL policy to match on all source IP addresses.
• Port Operator: Select one of the following options to specify a comparison operator for the
TCP or UDP port number. This option is enabled only when you specify TCP or UDP as the IP
protocol in Protocol Match.
• None: The policy does not apply any comparison operator for the TCP or UDP port
number.
• Greater than: The policy applies to TCP or UDP port numbers greater than the port
number or name you enter.
• Less than: The policy applies to TCP or UDP port numbers that are less than the port
number or name you enter.
• Equal: The policy applies to TCP or UDP port name or number you enter.
• Not equal: The policy applies to all TCP or UDP port numbers except the port number
or name you enter.
• Range: The policy applies to all TCP or UDP port numbers that are between the first
and second port number or name you enter. Enter the range in the Port Match fields.
The range is from 0 through 65,535.