Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 253)

Brocade Virtual ADX Graphical User Interface Guide 241
53-1003242-01
Chapter
17
Restarting the System
In this chapter
• System restart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 241
System restart
To reboot the Brocade Virtual ADX, perform the following steps within the Maintain tab.
1. Click System from the menu bar.
2. From the sidebar, select Reboot.
The Reboot page is displayed, as shown in Figure 168 .
FIGURE 168 Rebooting theBrocade Virtual ADX
3. Select Primary or Secondary for image file. By default, the system is configured to boot from
the primary memory.
4. Select Always reboot using the selected image file check box to set the selected image file as
the configured boot image.
5. Select Save Configuration check box to specify if the running configuration must be saved
before reboot.
NOTE
If you select the Always reboot using the selected image file check box, the Save Configuration
check box is selected and the running configuration is saved automatically.
6. Click Reboot to reboot the Brocade Virtual ADX.