Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) - Manual (Page 117)

Brocade Virtual ADX Graphical User Interface Guide 105
53-1003242-01
Health checks
7
Configuring a match list policy
The Brocade Virtual ADX currently supports compound and simple content-matching statements
under the match-list configuration. This enhancement adds support for “start” and “end”
statements in the match-list configuration.
You can configure a match list policy to mark the server port up or down when the rule defined in
the match list is met.
To create a match list policy on the Brocade Virtual ADX, perform the following steps within the
Configure tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Health Checks, and then select Match Lists.
The Match Lists page is displayed, as shown in Figure 85 .
3. Click New at the bottom of the Match Lists page.
The Match List - new page tab is displayed, as shown in Figure 86 .
FIGURE 86 Configuring match list
4. Provide the following information:
• Name: Enter the name of the match list.
• Default State: Specifies the selection criteria in the matching list. Click Up or Down.
5. Under Rule, select one of the following conditions from the Match Condition list to define a
rule:
• String Starts With: Specifies the string that should match with the beginning string of the
response sent by the real server. Select String Starts With and enter the string that in the
Start String field.
• String Ends With: Specifies the string that should match with the string present at the end
of response sent by the real server. Select String Ends With, and enter the string in the
Ends String field.