Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 89)

Software versions installed and running on a device
Use the following methods to display the software versions running on the device and the versions
installed in flash memory.
Determining the flash image version running on the device
To determine the flash image version running on a device, enter the show version command at any
level of the CLI. Some examples are shown below.
Compact devices
To determine the flash image version running on a Compact device, enter the show version command
at any level of the CLI. The following shows an example output.
device#show version
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserved.
UNIT 1: compiled on Mar 2 2012 at 12:38:17 labeled as ICX64S07400
(10360844 bytes) from Primary ICX64S07400.bin
SW: Version 07.4.00T311
Boot-Monitor Image size = 774980, Version:07.4.00T310 (kxz07400)
HW: Stackable ICX6450-24
==========================================================================
UNIT 1: SL 1: ICX6450-24 24-port Management Module
Serial #: BZSxxxxxxxx
License: BASE_SOFT_PACKAGE (LID: dbuFJJHiFFi)
P-ENGINE 0: type DEF0, rev 01
==========================================================================
UNIT 1: SL 2: ICX6450-SFP-Plus 4port 40G Module
==========================================================================
800 MHz ARM processor ARMv5TE, 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 3 minutes 39 seconds
The system : started=warm start reloaded=by "reload"
The version information is shown in bold type in this example:
• "03.0.00T53" indicates the flash code version number. The "T53" is used by Brocade for record
keeping.
• "labeled as FER03000" indicates the flash code image label. The label indicates the image type and
version and is especially useful if you change the image file name.
• "Primary fer03000.bin" indicates the flash code image file name that was loaded.
Displaying flash image version on chassis devices
To determine the flash image version running on a chassis device, enter the show version command
at any level of the CLI. The following is an example output.
device#show version
==========================================================================
Active Management CPU [Slot-9]:
SW: Version 07.4.00T3e3 Copyright (c) 1996-2012 Brocade Communications Systems,
Inc. All rights reserved.
Compiled on Mar 02 2012 at 11:54:29 labeled as SXR07400
(4585331 bytes) Primary /GA/SXR07400.bin
BootROM: Version 07.2.00T3e5 (FEv2)
Chassis Serial #: Bxxxxxxxxx
License: SX_V6_HW_ROUTER_IPv6_SOFT_PACKAGE (LID: yGFJGOiFLd)
HW: Chassis FastIron SX 800-PREM6 (PROM-TYPE SX-FIL3U-6-IPV6)
==========================================================================
Software versions installed and running on a device
FastIron Ethernet Switch Administration Guide 89
53-1003075-02