Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 173)

FIGURE 7 TTL TLV packet format
MIB support
Brocade devices support the following standard management information base (MIB) modules:
• LLDP-MIB
• LLDP-EXT-DOT1-MIB
• LLDP-EXT-DOT3-MIB
• LLDP-EXT-MED-MIB
Syslog messages
Syslog messages for LLDP provide management applications with information related to MIB data
consistency and general status. These Syslog messages correspond to the lldpRemTablesChange
SNMP notifications. Refer to
Enabling LLDP SNMP notifications and Syslog messages on page 178.
Syslog messages for LLDP-MED provide management applications with information related to topology
changes. These Syslog messages correspond to the lldpXMedTopologyChangeDetected SNMP
notifications. Refer to
Enabling SNMP notifications and Syslog messagesfor LLDP-MED topology
changes on page 188.
LLDP configuration
This section describes how to enable and configure LLDP.
The following table lists the LLDP global-level tasks and the default behavior/value for each task.
LLDP global configuration tasks and default behavior /value TABLE 21
Global task Default behavior / value when LLDP is enabled
Enabling LLDP on a global basis Disabled
Specifying the maximum number of LLDP
neighbors per device Automatically set to 392 neighbors per device
MIB support
FastIron Ethernet Switch Administration Guide 173
53-1003075-02