Viewing configuration information – Brocade FastIron Ethernet Switch Administration Guide User Manual
Page 230
To view the software and hardware details for the system, enter the show version command. The
following shows an example output.
device#show version
==========================================================================
Active Management CPU [Slot-9]:
SW: Version 04.3.00b17T3e3 Copyright (c) 1996-2008 Brocade Communications, Inc.,
Inc.
Compiled on Sep 25 2008 at 04:09:20 labeled as SXR04300b17
(4031365 bytes) from Secondary sxr04300b17.bin
BootROM: Version 04.0.00T3e5 (FEv2)
HW: ANR-Chassis FastIron SX 1600-PREM (PROM-TYPE SX-FIL3U)
Serial #: TExxxxxxxx
==========================================================================
SL 3: SX-FI424C 24-port Gig Copper
Serial #: CYxxxxxxxxx
P-ASIC 4: type 00D1, rev D2 subrev 00
P-ASIC 5: type 00D1, rev D2 subrev 00
==========================================================================
SL 9: SX-FI8GMR4 8-port Management
Serial #: CHxxxxxxxx
P-ASIC 16: type 00D1, rev D2 subrev 00
==========================================================================
SL 14: SX-FI42XGW 2-port 10G LAN/WAN
Serial #: Invalid
P-ASIC 26: type 01D1, rev 00 subrev 00
P-ASIC 27: type 01D1, rev 00 subrev 00
==========================================================================
Active Management Module:
660 MHz Power PC processor 8541 (version 32/0020) 66 MHz bus
512 KB boot flash memory
16384 KB code flash memory
512 MB DRAM
The system uptime is 2 minutes 13 seconds
The system : started=warm start reloaded=by "reload"
*** NOT FOR PRODUCTION ***
*** AUTO SHUTDOWN IS OFF. PLEASE ACTIVATE WITH auto-shutdown ***
The following hardware details are listed in the output of the show version command:
• Chassis type
• PROM type (if applicable)
• Chassis serial number
• Management and interface module serial numbers and ASIC types
For a description of the software details in the output of the show version command, refer to the
section
Syntax: show version
Viewing configuration information
You can view a variety of configuration details and statistics with the show option. The show option
provides a convenient way to check configuration changes before saving them to flash.
The show options available will vary for Layer 2 Switches and Layer 3 Switches and by configuration
level.
To determine the available show commands for the system or a specific level of the CLI, enter the
following command.
device#show ?
Syntax: show option
You also can enter "show" at the command prompt, then press the TAB key.
Viewing configuration information
230
FastIron Ethernet Switch Administration Guide
53-1003075-02