Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 356)

Message OSPF virtual nbr state changed, rid router-id ,
nbr addr ip-addr , nbr rid nbr-router-id , state
ospf-state
Explanation Indicates that the state of an OSPF virtual neighbor has changed.
The router-id is the router ID of the Brocade device.
The ip-addr is the IP address of the neighbor.
The nbr-router-id is the router ID of the neighbor.
The ospf-state indicates the state to which the interface has changed and
can be one of the following:
• down
• attempt
• initializing
• 2-way
• exchange start
• exchange
• loading
• full
• unknown
Message
Level Notification
Message Transit ICMP in interface portnum exceeds num
burst packets, stopping for num seconds!!
Explanation Threshold parameters for ICMP transit (through) traffic have been
configured on an interface, and the maximum burst size for ICMP packets
on the interface has been exceeded.
The portnum is the port number.
The first num is the maximum burst size (maximum number of packets
allowed).
The second num is the number of seconds during which additional ICMP
packets will be blocked on the interface.
NOTE
This message can occur in response to an attempted Smurf attack.
Message
Level Notification
Message Transit TCP in interface portnum exceeds num
burst packets, stopping for num seconds!
Explanation Threshold parameters for TCP transit (through) traffic have been configured
on an interface, and the maximum burst size for TCP packets on the
interface has been exceeded.
Syslog messages
356 FastIron Ethernet Switch Administration Guide
53-1003075-02