Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 199)

For a PSE (Network Connectivity device), the power level represents the amount of power that is
available on the port at the time. If the PSE is operating in reduced power (i.e., it is using backup
power), the reduced power capacity is advertised as long as the condition persists.
By default, LLDP-MED power-via-MDI information is automatically advertised when LLDP-MED is
enabled, the port is a POE port, and POE is enabled on the port. To disable this advertisement, enter a
command such as the following.
device(config)#no lldp advertise med-power-via-mdi ports e 2/4 to 2/12
The LLDP-MED power-via-MDI advertisement will appear similar to the following on the remote device,
and in the CLI display output on the Brocade device (show lldp local-info ).
+ MED Extended Power via MDI
Power Type : PSE device
Power Source : Unknown Power Source
Power Priority : Low (3)
Power Value : 6.5 watts (PSE equivalent: 7005 mWatts)
Syntax:[no] lldp advertise med-power-via-mdi ports ethernet port-list | all
Displaying LLDP statistics and configuration settings
You can use the following CLI show commands to display information about LLDP settings and
statistics:
• show lldp - Displays a summary of the LLDP configuration settings.
• show lldp statistics - Displays LLDP global and per-port statistics.
• show lldp neighbors - Displays a list of the current LLDP neighbors.
• show lldp neighbors detail - Displays the details of the latest advertisements received from LLDP
neighbors.
• show lldp local-info - Displays the details of the LLDP advertisements that will be transmitted on
each port.
This above show commands are described in this section.
LLDP configuration summary
To display a summary of the LLDP configuration settings on the device, enter the show lldp command
at any level of the CLI.
The following shows an example report.
device#show lldp
LLDP transmit interval : 10 seconds
LLDP transmit hold multiplier : 4 (transmit TTL: 40 seconds)
LLDP transmit delay : 1 seconds
LLDP SNMP notification interval : 5 seconds
LLDP reinitialize delay : 1 seconds
LLDP-MED fast start repeat count : 3
LLDP maximum neighbors : 392
LLDP maximum neighbors per port : 4
Syntax: show lldp
The following table describes the information displayed by the show lldp statistics command.
Displaying LLDP statistics and configuration settings
FastIron Ethernet Switch Administration Guide 199
53-1003075-02