Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 314)

Specifies the stack unit on which errors to be displayed.
all
Displays errors for all stack units.
link-error
Displays the link error count on FCX and ICX devices. This option is not supported on FSX
devices.
stack-unit
Specifies the stack unit on which errors to be displayed.
all
Displays errors for all stack units.
Modes Privileged EXEC mode.
Global configuration mode.
Examples The following displays all fabric adaptor statistics on an FSX device:
Brocade# show sysmon counters fa link all
Sysmon FA HG.link error detected (number of times)
FA-link0 FA-
link1 FA-link2 FA-link3
SLOT FA-dev Sync/FC(RX,TX) Sync/
FC(RX,TX) Sync/FC(RX,TX)Sync/FC(RX,TX)
1 0 0/(0,0) 0/(0,0) 0/
(0,0) 0/(0,0)
2 2 0/(0,0) 0/(0,0) 0/
(0,0) 0/(0,0)
9 16 1751/(1750,1750) 0/(0,0) 0/
(0,0) 0/(0,0)
9 17 0/(0,0) 0/(0,0) 0/
(0,0) 0/(0,0)
The following example displays the error events that sysmon has recorded for the fabric adaptor 0.
Brocade# show sysmon counters fa error 0
Sysmon error detected on: SLOT 1, FA 0(number of times)
****PUMA Device 0 VOQUnit0 error detect
Set 0 EnQ Drop detect = 0
Set 1 EnQ Drop detect = 0
Set 2 EnQ Drop detect = 0
Set 3 EnQ Drop detect = 0
tail drop detect = 0 filter drop detect = 0, ecc drop detect = 0
****PUMA Device 0 VOQUnit1 error detect
Set 0 EnQ Drop detect = 0
Set 1 EnQ Drop detect = 0
Set 2 EnQ Drop detect = 0
Set 3 EnQ Drop detect = 0
tail drop detect = 0 filter drop detect = 0, ecc drop detect = 0
****PUMA Device 0 CRX error detect
CRC detect = 0, Lost SOP.EOP detect = 0, no egress Buf detect = 0
fifo full detect = 0, UC congest detect = 0, MC congest detect = 0
bad buf alloc detect = 0, e2e drop detect = 0
System Monitoring
314 FastIron Ethernet Switch Administration Guide
53-1003075-02