Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 329)

Message DOT1X: port portnum - MAC mac address Downloading
an IP ACL, but IP ACL have no effect on a switch
port
Explanation The RADIUS server returned an IP ACL, but the portnum is a switch port
(no IP address).
Message Level Informational
Message DOT1X:port portnum - MAC mac address Error -
could not add all MAC filters
Explanation The Brocade device was unable to implement the MAC address filters
returned by the RADIUS server.
Message Level Informational
Message DOT1X: port portnum - MAC mac address Invalid MAC
filter ID - this ID doesn't exist
Explanation The MAC address filter ID returned by the RADIUS server does not exist in
the Brocade configuration.
Message Level Informational
Message DOT1X: port portnum - MAC mac address Invalid MAC
filter ID - this ID is user defined and cannot be
used
Explanation The port was assigned a MAC address filter ID that had been dynamically
created by another user.
Message Level Informational
Message DOT1X: port portnum - MAC mac address is
unauthorized because system resource is not
enough or the invalid information to set the
dynamic assigned IP ACLs or MAC address filters
Explanation 802.1X authentication failed for the Client with the specified mac address
on the specified portnum either due to insufficient system resources on the
device, or due to invalid IP ACL or MAC address filter information returned
by the RADIUS server.
Message
Level Informational
Syslog messages
FastIron Ethernet Switch Administration Guide 329
53-1003075-02