Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 210)

Cable statistics TABLE 27
This line... Displays...
Port The port that was tested.
Speed The port current line speed.
Local pair The local link name. Refer to the previous local pair definition table.
Pair Length The cable length when terminated, or the distance to the point of fault when the line is not up.
Remote pair The remote link name.
Pair status The status of the link. This field displays one of the following:
• Terminated: The link is up.
• Shorted: A short is detected in the cable.
• Open: An opening is detected in the cable.
• ImpedMis: The impedance is mismatched.
• Failed: The TDR test failed.
The following table lists the fiber optic transceivers supported on FastIron devices.
Supported fiber optic transceivers TABLE 28
Label Type Brocade part number Supports Digital
Optical Monitoring?
E1MG-BXD 1000Base-BXD 33005-000 No
E1MG-BXU 1000Base-BXU 33006-000 No
E1MG-LHA-OM 1000Base-LHA 33212-100 Yes
E1MG-LX-OM 1000Base-LX 33211-100 Yes
E1MG-100FX-LR-OM 100Base-FX-LR, 40 km 33226-100 Yes
E1MG-100FX-OM 100Base-FX 33224-100 Yes
E1MG-100FX-IR-OM 100Base-FX-IR, 15 km 33225-100 Yes
E1MG-SX-OM 1000Base-SX 33210-100 Yes
E1MG-TX 1000Base-T Copper 33002-100 No
10G-XFP-ER 10GBase-ER XFP, 40 km 33013-000 Yes
10G-XFP-LR 10GBase-LR XFP, 10 km 33012-000 Yes
10G-XFP-SR 10GBase-SR XFP 33011-000 Yes
Hardware Component Monitoring
210 FastIron Ethernet Switch Administration Guide
53-1003075-02