Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 280)

4/15 On On 8075 9500 802.3af n/a 3 n/a
4/16 On On 4131 9500 802.3af Class 1 3 n/a
4/17 On On 2347 9500 802.3af n/a 3 n/a
4/18 On Off 0 9500 n/a n/a 3 n/a
4/19 On On 5352 9500 Legacy n/a 3 n/a
4/20 On On 7981 9500 802.3af n/a 3 n/a
4/21 On On 12958 13000 802.3af Class 3 3 n/a
4/22 On On 12958 13000 802.3af Class 3 3 n/a
4/23 On On 13052 13000 802.3af Class 3 3 n/a
4/24 On On 12864 13000 802.3af Class 3 3 n/a
--------------------------------------------------------------------------
Total 137367 242000
... some lines omitted for brevity...
Grand Total 1846673 2127400
Syntax: show inline power [port]
Field definitions for the show inline power command TABLE 40
Column Definition
Power Capacity The total PoE power supply capacity and the amount of available power (current free) for PoE
power consuming devices. Both values are shown in milliwatts.
Power
Allocations The number of times the FSX fulfilled PoE requests for power.
Port The slot number and port number.
Admin State Specifies whether or not Power over Ethernet has been enabled on the port. This value can be
one of the following:
• On - The inline power command was issued on the port.
• Off - The inline power command has not been issued on the port.
Oper State Shows the status of inline power on the port. This value can be one of the following:
• On - The PoE power supply is delivering inline power to the PD.
• Off - The PoE power supply is not delivering inline power to the PD.
• Denied - The port is in standby mode (waiting for power) because the FSX does not currently
have enough available power for the port.
NOTE
When you enable a port using the CLI, it may take 12 or more seconds before the operational
state of that port is displayed correctly in the show inline power output.
Power
Consumed The number of current, actual milliwatts that the PD is consuming.
Power
Allocated The number of milliwatts allocated to the port. This value is either the default or configured
maximum power level, or the power class that was automatically detected by the device.
Power over Ethernet
280 FastIron Ethernet Switch Administration Guide
53-1003075-02