Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 271)

U3-MSG: PoE Info: Resetting module in slot
1....completed.<======================================resetting twice===========
3. After downloading the firmware into the controller, the controller resets and reboot with the new PoE
firmware, You should see output similar to the following.
[MEMBER]local-3@ICX6450-24P Router>Download request from active unit 1 mac =
748e.f8dc.b39c
Downloading - poe.fw
Done.
PoE Info: Resetting in slot 1....
PoE Error: Device 0 failed to start on PoE module.<====================PoE Errors
on local console==========
PoE Error: Device 1 failed to start on PoE module.<===============PoE error
Resetting module in slot 1 again to recover from dev fault<=======Dev
fault=========
PoE Info: Hard Resetting in slot 1....<=====Hard reset=======
PoE Info: Programming Brocade defaults.....
PoE Info: Programming Brocade defaults. Step 1: Writing port defaults on module in
slot 1....
PoE Info: Programming Brocade Defaults: Step 2: Writing PM defaults on module in
slot 1.
PoE Info: Programming Brocade defaults. Step 3: Writing user byte 0xf0 on module
in slot 1.
PoE Info: Programming Brocade defaults. Step 4: Saving settings on module in slot
1.
PoE Info: Programming Brocade defaults....completed.
[MEMBER]local-3@ICX6450-24P Router>
NOTE
If you are attempting to transfer a file using TFTP but have received an error message, refer to
Firmware image file types .
Upgrading the PoE firmware file using SCP
To use the PoE feature, download the PoE firmware file. You can then install it using SCP as shown
below:
NOTE
In a stack, you must install the PoE firmware on each individual member unit.
1. Place the PoE firmware file on an SCP-enabled host to which the Brocade device has access.
2. Copy the PoE firmware file from the SCP-enabled host into the switch. To do so, enter the following
command on the SCP-enabled host:
For FCX and ICX 6610 devices:
pscp firmware hostname@management-ip:firmware:stackid:stack-id
For FSX devices:
pscp firmware hostname@management-ip:firmware:moduleid:module-id
For example:
C:/>pscp fsx_poe_07400.fw [email protected]:firmware:stackid:1
The process of PoE firmware installation begins. On the FastIron device CLI, you should see the
output similar to the following:
Brocade(config)#scp download successful stackId = 1 file name = poe-fw
Sending PoE Firmware to Stack Unit 1.
PoE Warning: Upgrading firmware in slot 1....DO NOT SWITCH OVER OR POWER DOWN
THE UNIT.
PoE Info: FW Download on slot 1...sending download command...
PoE Info: FW Download on slot 1...TPE response received.
PoE Info: FW Download on slot 1...sending erase command...
Upgrading the PoE firmware file using SCP
FastIron Ethernet Switch Administration Guide 271
53-1003075-02